•   1-855-426-FT86(3886)

GrimmSpeed Boost Solenoid

GrimmSpeed Boost Solenoid

SKU: GRM 057027

More Views

CA$157.52
OR
Features and Specifications
The GrimmSpeed Electronic Boost Control Solenoid is designed to work with your

factory computer (requires tuning). It will not reduce the life of your factory computer

because it is designed to draw the same ammount of power as the factory BCS but

flows better and reacts faster. It plugs in and requires no splicing or soldering of resistors.

With the included bracket you can bolt it in, plug in the connector, and start tuning for fast

boost response, increased boost pressure and free up lots of power. Planning on

returning the car to stock? Just reverse installation.



*Why run an Electronic BCS over a Manual Boost Controller?*

A MBC allows you to run higher than stock boost levels by preventing the wastegate

from opening at its rated pressure. It does a great job at this but if boost is available

under the MBC setting it will give you that full boost. So for instance, you set your MBC to

18psi because from 3000-6000rpm thats what you want. But then say you get detonation

with 18psi when you are at 7000rpm unless you are below 16psi. With a MBC, you do

not have this control so you are forced to run 16psi through the entire rev range. With an
electronic boost controller you could run 18psi from 3000-6000 and 16psi at 7000rpm

because you can tune the boost map in the ECU which will allow you to run the

maximum amount of boost at every given rpm. This gives you more power throughout the
range and better control. Revolutionizing the boost solenoid market, we have created

model specific install brackets that allow you to directly fit our Boost Solenoid into your

vehicle for a factory fit. No more Zip-tying! We give you the factory fitment you have

been waiting for.



Staying with the OEM fitment theme, the GrimmSpeed Electronic Boost Control Solenoid

uses an OEM style wiring harness so you can simply unplug your OEM solenoid and plug

ours in. No more cutting the oem wiring and crimping wires together!



Also new to the electronic boost solenoid market, we have used ultra low-profile hose

fittings to keep the unit as small and clean as possible. The hose fittings are nickel plated

brass so you don't have to worry about them snapping off like the plastic hose fittings!


No reviews have been found