REAR BUMPER REFLECTOR OVERLAYS

REFLECTOR BLACKOUT OVERLAYS

This simple kit allowed you to blackout the rear reflectors on your vehicle. These are easy to install and can be removed at a later time without damaging the reflector.

INSTRUCTIONS

Clean and wet the surface of the overlay and the rear reflector using of a mixture of soap (1 drop of dishwasher soap) and water can help you align the piece. Place it in the appropriate area and squeegee the water out with your fingers. This will prevent damage to the surface of the overlay. Use of a heat gun or hair dryer can help contour the material over the words written on the lens. Apply heat in small amounts until you can tell how it affects the material. It will allow the material to stretch and the water to dry. Allow 24 hours for the overlay to fully stick to the reflector. Once completely dry, they will hold up in automatic car washes and against most power washing.