CX Racing Turbo Header Manifold Downpipe Kit for 05-14 Ford Mustang 4.6L V8 NA-T Coolant PS Tank

CXRacing Single Turbo Header Downpipe kit for 5th Generation 2005-2014 Ford Mustang 4.6L V8

Comes with T76 Turbo (0.81 AR Turbine Housing for Fast Spool), Turbo Header, Cross Pipe, Wastegate, Dump Tube, Coolant Reservoir and Power Steering Fluid Tanks, Oval Intake Elbow

Note: Intercooler and Piping Kit, Radiator Piping Kit, Radiator Fan Shroud and Fans Are NOT Included.

Perfect Fitment, No Cut, Keeps AC, Supports Up to 700 HP Depends on Engine Build and Boost Level.

Note:
1. Need to Remove Stock Radiator Fan Shroud, to Clear Room for Turbo. But Can Fit Slim Electrical Fans, Also Fits Thicker Aftermarket Aluminum Radiator with Slim Fans.
2. Need to Extend Stock MAF Sensor Wire, Due to Change of Intake Location.
3. Need to Replace Stock Coolant Tank and Power Steering Fluid Reservoir Tank (Included)
4. Can’t Keep Windshield Washer Tank
5. Downpipe End Is 3", Need to Weld Flange or Connect to Your Existing Exhaust System.
6. This Is for Turbo Hardware Kit ONLY. You Will Need to Build Your Engine and Upgrade Your Fuel System and Re-Tune Your Engine Management System.

This is CXRacing's Newest Product for The Application Stated. All Products Are Developed from The Ground up in Our R&D Center Based in The USA. Our Parts Are Designed and Built for Improved Performance Gains, with Excellent Fitment and Ease of Installation.

APPLICATION(S):
- Chassis: 5th Generation 2005-2014 Ford Mustang
- Engine: 4.6L V8

All Other Parts Shown are NOT INCLUDED. We Do Offer Different Combination of Kits Which Include These Other Products Shown, Please Check Our Other Items or Contact Us For More Information.

PRODUCT(S):
- Pair of Header x1
- T76 Turbo Charger x1
- 44mm 8PSI Vband Wastegate x2
- Oil Filter Sandwich and Oil Line Kit x1
- Cross Pipe x2
- Downpipe x2
- WG Dump Tube x2
- Coolant/PS Fluid Tank x1
- Oval to 3" Intake Elbow x1
- T4 Turbo Y Elbow Pipe x1
- Set of Vband Clamp x1

Optional One Dual Ball Bearing Turbos is Available with $250 Extra, Please Select the Ball Bearing Option When Buying.

TECHNICAL SPECIFICATIONS:
T76 Turbo Charger

Air Inlet
4"
Compressed Air Outlet
2.5"
Bearing
Wet Floating Bearings
Turbine Housing Flange
Standard T4
Exhaust Outlet
3" V-Band
Cooling
Oil Cooled
Compressor
76mm
Turbine
P Trim .81 A/R
Compressor Wheel (Major/Exducer)
102.4mm/76.7 mm
Turbine Wheel (Major/Inducer)
74.1mm/64.6mm